Operation Manual

SET MODE

New2001

D Auto power OFF (AP OFF)

The receiver can be set to automatically turn OFF, and

sound a beep, after a specified period when no key opera-

tions are performed.

OFF (default), times of 30, 60, 90, 120 minutes and BUSY

can be specified. The (repetitive) period is retained even

when the receiver is turned OFF, even by the auto power

OFF function. To cancel the function, select “OFF”.

When “BUSY” is selected, the receiver will automatically turn

OFF when no key operations are performed and no signal is

received for 3 minutes.

D Scan pause timer (PAUSE)

Selects the scan pause time. When receiving signals, the

scan pauses according to the scan pause time.

(default: 10SEC)

• 2–20SEC : The scan pauses for 2–20 seconds on a

received signal, and is selected in 2 seconds

steps.

• HOLD : The scan pauses on a received signal until it

disappears. Rotate [DIAL] to resume manually.

D Scan resume timer (RESUME)

Selects the scan resume time. The scan resumes after the

speciﬁed period after the received signal disappears.

(default: 2SEC)

• 0SEC : The scan resumes immediately after the

received signal disappears.

• 1–5SEC : The scan pauses 1–5 seconds after the

received signal disappears.

• HOLD : The scan pauses on the received frequency,

even if the signal disappears. Rotate [DIAL]

to manually resume the scan.

The scan resume timer must be set shorter than the scan

pause timer, otherwise this timer will not be activated.

D Scan stop beep (STOP B)

Turns the scan stop beep function ON or OFF (default).

When the function is activated (“ON” is selected), a long

beep will sound each time a signal is received during a scan.