User Manual

18
Interactive Display
The iConnectAUDIO2
+
’s Interactive Display makes it simple to view and adjust analog
input and output levels, enable/disable 48V phantom power for condenser mics, and
perform various utility functions without using the iConfig software.
It consists of a capacitive touch panel with eight touch zones and dual 8-stage LED
meters, and a Rotary Control Knob that also performs various functions when it’s
pushed/double-pushed.
Meter Modes
There are two meter viewing modes. Successive touches of In, Out, or Phones toggles
between the two modes:
Signal Level mode, indicated by a green bottom row LED. The LED meters display VU
(the signal level).
Gain Set mode, indicated by a red bottom row LED. This is like showing the position of
a volume control in the meters (the Rotary Knob is continuous, so you can't tell the
position by looking at the knob).
The 48V/Inst touch zone has no effect on the viewing mode, since it’s an on/off function.
Basic Operation
1. Touch the region centered around one of the four indicators on the bottom row to
select a function: 48V/Inst, In, Out, or Phones. Note that the 48V/Instr indicator has two
states: red and green. Green indicates the mode for changing 48V phantom power
settings, while red indicates the mode for for changing between line and instrument
impedance settings. Subsequent touches of the 48V/Inst indicator toggles between
these two modes.
2. Touch numbers 1 through 4 on the top row to select an analog input or output for
adjustment (or to change 48V phantom power or line/inst mode for the inputs).
3. Turn the Rotary Knob to adjust the In, Out, or Phones level.
48V
Inst