User Manual

v.1.2
7
Quick Start Guide
By default your iConnectAUDIO4+ is pre-configured to work with Digital Audio
Workstation (DAW) software. All the interface’s audio inputs are routed to the computer
device(s) for recording, not directly to the audio outputs; you won’t hear anything if,
say, you plug in a mic without going through your audio/music software.
Furthermore, all the audio ins and outs are set all the way down, and need to be
raised. This Quick Start Guide will show you how to get sound running in and out of
your interface as simply as possible.
Audio hookup – connecting a Mac, PC, or iOS device
1. Connect a Mac or PC to USB Device Jack 1, using the supplied USB-A to USB-B
cable. *
2. Connect your powered monitors or power amp and speakers to Analog Out Jacks
1&2.
3. Connect the included iConnectivity power supply and plug it into the wall.
* For the purposes of a sound check, you can substitute an iOS device using the Lightning-to-
iConnectivity cable, and then skip to “Using the Interactive Display” a few paragraphs down
(there is no software to configure). But it’s important to install the iConfig software on a
computer (step 2 just below).
Software