User's Manual

1 Go to the Summary page.
2 Under Pictures, click on the picture thumbnail from the camera for which
you want to enable video. An expanded window will open.
3 Click on menu item, Live Video, shown below. The menu item shown here
is inside of the expanded picture window.
4 You will then see the following dialog box. Record the IP address and port
number shown in the window (Here the IP address is 192.168.1.102 and the
port number is 80).
At this point you need to configure your location’s router to enable port
forwarding. LEAVE the window shown above open, as you will need it to finish
your work. Go to the next section.
Setting up port forwarding
To set up your camera to show video, you will need to establish port
forwarding for your camera. Port forwarding enables your home router to pass
streaming video through so that it can be accessed from your iControl
Summary page.
To set up port forwarding, you will need the router’s user name and password.
(Check your router’s user manual as you may have recorded the password and
user name there. Also, you may have used the default user name and password