User's Manual

Setting port forwarding for a NetGear router
Here are the steps for a typical NetGear router. Your NetGear router
screens may be different from those shown here and you should consult your
NetGear user manual for more information.
1 Select ‘Click here to go to your router’s home page’ from the ‘Camera
Not Accessible’ window. You will then need your user name and
password to access the administration page.
2 On your adminstration page, there will be an item called port forwarding
under Advanced in the left hand navigation bar that you will select to
enter the necessary information.
Here is an example of the portion of the setup screen for a NetGear router
showing
port forwarding already configured for an iControl camera.
To implement port forwarding, 1 Select the button, Add Custom Service. 2 Create
a Service name. In this example the Service name is Camera. 3 Enter the
Start port. In this example, it is 80. 4 Enter an End port. In this example, it is
80. 5 Enter the IP address obtained by following the instructions in prior
section entitled,