User's Manual

Screen shot from clicking on a picture in Pictures in Summary Page
5 Using your Door/Window Sensor
Once you have installed a Door’/Window Sensor in your house and it appears in
your iControl Summary page, you only have to activate the sensor once to make
it operational. To do so, open and close the door or window once to tell your
iControl box whether it is initially open or closed. You do not need to make any
other configuration changes or take any other set up actions.
Check on your Door/Window Sensor
The following describes how to see the status of your Door/Window Sensor.
1 Navigate to the Summary page.
2 Go to the Status window. In the image shown below, the Door/Window
Sensor is named ‘office slider window front 1’ and its state is closed.
This Door/Window Sensor recognizes that the office slider window is