User's Manual

See the status of your Lamp Module
1 Go to the Summary page. In the Status window, look for your Lamp
module. Scroll down if necessary to see it listed.
2 The lamp’s brightness level will be displayed.
8 Using your Motion Sensor
See the status of your Motion Sensor
To see the status of your Motion Sensor,
1 Go to the Summary page. In the Status window, look for the name you
gave your Motion Sensor. Scroll down if necessary to see it listed. A
yellow triangle next to the name of the Motion Sensor indicates that it has
recognized a change such as a person entering the room See Chapter 1
Getting Started for more information.
Occupied and Empty states
The term ‘Occupied’ means that the Motion Sensor has detected a person
moving in the area that it monitors over 40 pounds in weight. The term ‘Empty’
means that the Motion Sensor has not detected a person moving into the area it
monitors for several minutes.
If a person enters a monitored area, the Motion Sensor immediately
recognizes the change and reports that the area is occupied through your
iControl box which in turn displays the information on your Summary page.
If a person leaves the monitored area, the Motion Sensor ‘waits’ a few minutes
before reporting that the area is empty. This delay is to allow the Motion Sensor
to confirm that the person has left the room. The yellow triangle status icon
disappears when the status changes to ‘empty’.
9 Adding Additional Devices
This chapter describes how to add additional devices to your iControl System.
The basic steps are shown below:
1 Write down the serial number, sometimes identified as a DL or S/N
number or ID number, of your device. Here are examples for the devices
available in the Starter Kit to help you confirm that you are recording the
appropriate serial number: