User's Manual

5 You can give the device a name such as hallway light, back door light,
office camera, Dad’s keychain remote, or hallway watcher for a motion
sensor.
6 Enter the identifier in the ID field. Here is an example of adding a
Door/Window Sensor
7 Click on the Add button to add the device to your iControl System
8 You will receive a confirmation in the Status screen that you have
successfully added the device.
9 You will be returned to the System page where you will see the new device.
A yellow circle will be adjacent to the device name indicating that the system is
still installing that device. You can obtain additional information about any device
by clicking on its name. If you click on the screen , you will see a similar table to
that shown below. Here is an example of a camera is being installed.