User's Manual

What are the default buttons? Unlock Button: Change to Home mode Lock
Button: Change to Away mode Light Button: Press once to turn on all the
lights controlled by a lamp module. Press again to turn them off. Star
Button: Take a picture
Motion Sensor How do I test my motion sensor?
1 Remove sensor from mounting plate, then reattach. You have 60 seconds
2 Walk across room and wait for sensor light to turn on
3 Stop, stand still and wait for sensor light to turn off.
4 Repeat Steps 2 & 3 until entire area has been tested
5 Leave the room for at least 60 seconds. After 60 seconds without motion,
walk test mode time expires and the light on the sensor no longer
activates when motion is detected.
Will the Motion Sensor sense my pets?
No for pets less than 40 pounds. This also means that it will not sense children
less than
40 pounds.
11 Terms and Conditions, Warranty
Information, and More
This chapter is in development
iControl Privacy policy The written policy will be available when the product is
shipping and will be provided in this section as well as on the website where the
customer can see access it during the purchase process.
FCC Compliance
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try and correct the interference by one or more
of the following measures: