User's Manual

• Re-orient or locate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Modifications made to the iControl Gateway, Keychain Remote, IP
Camera, Motion Sensor, Door Window Sensors and associated sensors
unless expressly approved by iControl, could void the user’s authority to
operate the equipment.
The term “IC:” before the radio certification number only
signifies that Industry Canada technical specifications were
met.
Appendix A Battery Maintenance
iControl box No battery maintenance is required as it does not contain a battery.
iControl Wired Camera No battery maintenance is required as it does not contain
a battery.
iControl Door/Window Sensor The Sensor (the larger module of the two—sensor
and magnet) requires a 3 VDC battery and is designed for long battery life. To
change the battery, follow these steps:
1 Remove the cover from the base plate by using a pen knife or similar
tool to pry them apart.
2 Slide out the battery and replace it with a new one.
iControl Lamp Module No battery maintenance is required as it does not contain
a battery.
iControl Motion Sensor The motion sensor uses 2 AA batteries and is designed
for long battery life. To change the battery, follow these steps:
1 Open the Motion Sensor via the sensor body button and pull the sensor
body away from the mounting plate. Most of the motion sensor is now
removed from the mounting plate.
2 Press the tabs at the top and bottom locations and pull the sensor face
plate off of the sensor’s body.
3 Replace the batteries.
4 Replace the sensor body and face plate.
5 Go to the System tab to see if it shows the device.