User's Manual

begin using your System. The Summary page consists of the following series of
windows.
Status window The top portion of this window indicates the overall status of
the system and the current mode the system is in. The status light can have
three possible colors as described below:
Green – No alarm conditions. System operating normally
Yellow – One or mode device alarm conditions (e.g. motion detected)
Red – System problem (e.g. iControl box communication problem).
The Status window also shows the current mode for your iControl System.
Here, the System is in ‘Away Mode’.
The rest of the Status window is a list showing the current state of all the devices
in the system. In the screen shown earlier, three devices appear: a door/window
sensor called ‘Back door’; a Thermostat showing the current temperature at 74
degree and its Heat Setpoint to of 69 degrees and Cooling Setpoint of 61
degrees; and a door/window sensor labeled ‘front door’.
Your house may have many more devices than three and to view these you
place your cursor over the up or down arrow to scroll to see additional devices or
on the small box inside the scroll bar.
Current states Current states refer to the status of all of your devices. If a device
has a yellow triangle next to it, the triangle indicates that the device has
recognized a change that creates an alarm. The following table shows the
possible states and the alarm conditions of Starter Kit devices.