User's Manual

Printed Documentation
To mount your Motion sensor, you will need the screws that come with the sensor, a
pencil, a ruler, a drill, and a screwdriver. The following diagrams show the sequence of
the installation process:
Press Down Here to detach back. Optional screw. Unscrew if present.
Mount Motion sensor back to wall with 3/4” long screw and wall anchors. Snap the sensor body onto back.
For corner mount, drill here.
For wall mount, drill here.
When a Motion sensor is first installed, the sensor does an automatic test, and the LED
found on the upper front of the sensor turns red for five to ten seconds. The Motion
sensor requires an additional 60 seconds when there is no motion in the monitored area to
complete its test. This is the only time the LED turns red during normal operation. The