Owner's manual

4.22 99$PPCLLABC
Description: Change the CAN bus pair connection configuration. After setting
successfully, all parameters will take effective after system restart.
¾ Syntax: 99$PPCLLABC
99$PPC Command character
LL number of parameters, here fix to “03”
A Enable CAN bus pair connection flag, 0: Disable, 1: Enable
B Using TCP or UDP connection; 0: TCP, 1: UDP
C Act as a server or client; 0: server, 1: client
Note:
1. When A=0, B and C take no effective
2. When using UDP connection(B=1), C take no effective
3. When acting as a TCP client or using UDP method, users need
to set the destination IP address (section 4.23), so that the
7540D can work correctly.
¾ Response:
Valid Command: OK
Invalid command: ERROR
¾ Example:
Command: 99$PPC03101
Response: OK
Change the CAN bus pair connection configuration of the 7540D to
“enable CAN bus pair connection” and act as a TCP client.
Note:
1. This command can only be accepted by 7540D’s port 10000.
2. Supported by the firmware v1.06 or later.
i-7540D CAN-Ethernet Gateway User’s Manual (Version 1.4, April/2008)
88