Owners manual
TPD/VPD Series HMI Device User Manual
Copyright © 2015 ICP DAS Co., Ltd. All Rights Reserved. Page: 19
2.1.2 TPD-280-Mx/283-Mx/283U-Mx Series Models
Models supported include TPD-280-M1, TPD-280-M2, TPD-280-M3, TPD-283-M1, TPD-283-M2,
TPD-283-M3, TPD-283U-M1, TPD-283U-M2 and TPD-283U-M3.
1.
2.8” TFT LCD with Touch Panel
2.
Power/GND/RS-485 Connector (The TPD-283-Mx does not support this connector)
The TouchPAD device is equipped with a removable terminal block connector is
designed for easy and robust wiring. For more detailed information regarding the pin
assignments, refer to Section 2.2.1 TPD-280/283/430/433 Series Models.
3.
Rotary Switch (0 ~ 9)
The Rotary Switch is used to set the configuration modes, as follows:
For TPD-280-M1/M2/M3:
0. Run Only: This mode is used for running programs.
1. Update Only: This mode is used for updating programs.
For TPD-283-M1/M2/M3 and TPD-283U-M1/M2/M3:
0. Run & Update: This is a special run mode which is used in the development stage.
The TouchPAD device can be updated by a PC from the remote side through Ethernet.
1. Force Update: While the application run on the TouchPAD device seriously crashes,
use this mode to update a new application to the TouchPAD device.
2. Run Only: Simply run, a TouchPAD device cannot be updated in this mode.