Installation guide

I Single Package Air Conditioners
Cooling
1. Be sure that electric power is OFF
Installation Instructions
c. Condenser fan motor - ON
d. Circulating air blower - ON
2,
3.
4,
Set thermostat Heat-Cool select to COOL.
Adjust thermostat setting to below room tempera-
ture.
Turn electric power ON for approximately one min-
ute, then OFF. During power application check the
following:
a. Contactor - Contacts closing
b. Compressor - ON
5.
Turn electric power OFF, check the following:
a. Contactor contacts opening.
b. Compressor - OFF
c. Condenser fan motor - OFF
d. Circulating blower - OFF
Heating
If an Electric Heat Accessory is used, see its Installation
Manual for proper heater operation.
FIGURE 7 Blower Motor Speed Taps (3-Speed and 4-Speed Motors)
)TOR
I BE SURE TO CHECK BLOWER MOTOR I
SPEED DATA IN THE
TECHNICAL SUPPORT MANUAL.
1131