Quick Start Guide

About the Guide
Using the Dash App
Camera Installation
Step 2
Download the Dash App from Google Play or App Store.
Step 5
Step 4
Connect your smart phone to your 2.4 GHz Wi-Fi network, and
then follow the steps below to finish adding the Flooder.
Open the Dash App, and register a new account.
Step 3
When the Flooder camera has completely powered on, the
indicator light will flash green.
Note
If the Flooder camera Wi-Fi adoption fails, factory reset the
camera and repeat step 5.
Repeat step 5 to add multiple Flooder cameras.
Disclaimer
Turn the adjustment knobs to loosen the Flooder lights.
Adjust the light to access the mounting screw.
Use the installation hook to attach
the Flooder camera to the mounting
plate. This will free up both hands
during the installation.
Connect the power wires.
The white wire from the Flooder
camera is the neutral wire.
Connect this wire to the existing
neutral wire.
The black wire from the Flooder
camera is the hot wire. Connect
this wire to the reserved hot wire.
Step 7
Adjust the light and lens angles.
Be sure and keep the PIR Motion
Sensor parallel to the ground to
ensure optimal detection.
Step 1
Power on the Flooder camera.
Step 2
Install the mounting plate:
Without junction box
Place the mounting plate
to the junction box.
Install the mounting plate to the
middle of the opening with the
provided mounting hardware.
With junction box
Connect the bare copper wire
from the Flooder camera to the
existing ground wire using the
supplied wire nuts.
Step 5
When all wires are securely
fastened, mount the Flooder
camera to the mounting plate
using the provided mounting
screw.
Step 8 Step 6
Step 4
Step 3
Step 1
With power off at the breaker, remove the existing floodlight
from the junction box. Disconnect the existing wires and inspect
the surfaces to ensure a water tight seal.
Note
If there is a mounting plate attached to your junction box,
remove before installation.
If you do not have an existing junction box, you will need to hire
a licnsed electrician to install one. Also be sure to comply with
your local codes.
Note If the App has been previously installed be sure it is up to date.
This guide is for informational purposes only. A qualified &
licenced electrician is recommended for the installation of
the Flooder Camera.
All designs and software mentioned here are subject to
change without prior written notice.
All trademarks and registered trademarks mentioned are
the properties of their respective owners.
Please visit our website or contact your local installer for more
information.
•
•
•
Be sure to disconnect the power at the fuse or circuit
breaker before installation.
Verify that the supplied voltage is correct. Connect the
Flooder camera to a 100 ~240VAC 50/60 Hz power source.
Properly ground the Flooder camera.
We strongly suggest you hire a licensed electrician to
install the camera.
Risk of fire.
Do not connect near combustible or flammable surfaces.
Note
Do not connect the Flooder camera to a dimmer switch or
timer.
•
•
•
•
•
•
Risk of electrical shock.
WARNING