Quick Start Guide

MARGIN
GUIDES
Stay within the yellow
box. Do not let text go
beyond, instead move
to the next column or
start a new page.
4 | www.icrealtime.com
Figure 2-6
Waterproof connector installation for network port: For a device with a
plastic enclosure, you can directly rotate the dome enclosure
clockwise, cover the dome enclosure and complete installation. See
figure 2-6.
Step 6 Confirm that the inner gaskets are lined up accordingly and
then install the dome cover back on the dome body. Confirm all
screws are secured properly. See Figure 2-5.
Step 1: Keep the convex groove outward and install the rubber ring
into the network port, keep the smaller hole of the rubber ring
outward and install the fixing rubber ring into the main body of the
waterproof connector.
Step 2: Pull the network cable without crystal head through main
body of waterproof connector, fixing rubber ring and waterproof
locking cover, make the crystal head of network cable, and then
insert it into the network cable
Step 3: Put the main body of waterproof connector on the network
port and rotate it clockwise to lock the network port and waterproof
connector firmly
Step 4: Put the waterproof locking cover on the main body of
waterproof connector and rotate it clockwise to lock the waterproof
connector and waterproof locking cover firmly. It is recommended to
wrap the assembly with electrical tape for an extra protective
measure.
Figure 2-5