MB882HX-1SB 2.
English 1 Quick Installation Guide The dimensions of the SSD Xpander are the same as a standard 3.5” SATA HDD, and can be installed in the same manner using the same type of screws or the case’s fastening system. For an overview of the behavior once set up, please see Section 7 for the partition layout. Before proceeding with the installation, please make sure that the computer is powered off. Below is diagram to assist in the installation. Stromkabel 2 HDD 1 3 4 SSD Xpander 1.
English If the products shown above are different than the products included in the packaging, please contact the seller or retailer for replacement.
English 4-4 4-5 HD D Make sure the triangle icon on the cover is in line with the circle icon on the body, then close the lid. 5 How to remove the SSD 5-1 5-2 HDD HD D 6 SSD Xpander installation steps 1.Install the SSD into the SSD Xpander (See Section 4 of the manual for steps) 2.Place the SSD Xpander in a 3.5” drive bay of your choice. Secure the SSD Xpander using supplied 4 #6-32 screws, or the case’s fastening system. 3.Secure the 3.5" SATA HDDof your choice into another 3.5” drive bay.
English 4.On the rear of the SSD Xpander, the leftmost connections will be addressed first. The 15-pin power connection is to be hooked up to a 15-pin power cable from the power supply. The 7-pin SATA connection is to be hooked up to a 7-pin SATA cable from a SATA port on the motherboard or controller card being used. Power Supply HDD SSD Xpander Connect the SATA power connector from power supply to SSD Xpander, then connect the SATA data connector from motherboard to SSD Xpander 5.
English 7 SSD Xpander capacity expansion graphic integration The Icy Dock SSD Xpander is a means of combining an SSD’s high performance with the high capacity of a HDD. Once the SSD Xpander is set up, the SSD Xpander will automatically create 2 partitions. The first partition will be approximately double the capacity of the SSD used. The second partition will be the size of the HDD minus double the capacity of the SSD.
English Operating system algorithms: 1GB = 1,024 MB 1MB = 1,024 KB 1KB = 1,024 byte In so doing, the hard disk manufacturers 1GB = 1000 × 1000 × 1000 / (1024 × 1024 × 1024) ≈ Windows operating system 0.9313GB Hard disk manufacturers labeled 40GB ≈ 40 × 0.9313 ≈ Windows operating system 37.27GB Hard disk manufacturers marked 320GB ≈ 320 × 0.9313 ≈ Windows operating system 298.09GB Combination of the two disk partitions were 37.27 * 2 = 74.54GB, 298.09-74.54 = 223.
English A:Once the product has been repaired or replaced by Icy Dock or an authorized technician, the original SSD and HDD can be reconnected to the SSD Xpander to resume the original system set up. 5.Q： How can I verify that the SSD Xpander has been successfully integrated with the HDD? A: The first way is using the BIOS of your computer or motherboard, as described in the question 1. The second way is to check that the two partitions are created and that they are correct size.
9(5
