User`s manual

7
1. Enter GROUP SETUP MODE by typing
/E/D/FA
.
2. Press
<ENTER>
.
The reader should beep twice.
3. For the keyboard-less (PC boot-up) feature, type
4 <ENTER>
.
The reader
should beep twice.
Type
2 <ENTER>
.
The reader should beep twice.
4. Save the changes and exit the Group Setup Mode by typing
AZ
<ENTER>
.
The reader should beep four times.
Note: When confi gured to Terminal Type 42, the reader can work without an external
keyboard. It will be necessary to power down and restart the Omni after unplugging
the keyboard. To set up, you may plug a keyboard into the keyboard end of the wedge
cable at any time.
Note: The review command (AY) will display the version number and date in addition
to the terminal type setting while the reader is in setup mode.
The “reset all” command (AW) will return settings for all groups to their group de-
faults (as set at the factory).
General Selections (Group B)
The basic operating parameters of the Omni reader can be programmed with
this group of selections.
1. Enter GROUP SETUP MODE by typing
/E/D/FB
.
2. Press
<ENTER>
.
The reader should beep twice.
3. Type the two-character selection code for the feature you wish to change.
4. Press
<ENTER>
.
The reader should beep twice.
5. Type the one-character code for the change you wish to make.
6. Press
<ENTER>
.
The reader should beep twice.
7. Save the setting and exit the Group Setup Mode by typing
BZ
.
8. Press
<ENTER>
.
The reader should beep four times.
Note: To review the group’s current setting(s), type BY<ENTER> while in Group
Setup Mode. To reset the current setting(s) to its group default, type BX<ENTER>
while in the Group Setup Mode.