User's Manual

Page8of19

MountingtheViVOpayKioskII ExternalAntenna

Use the following instructions to mount the antenna on the exteriorof the kiosk:

Note: Verify the orientationof the ViVOpay Kiosk II Antenna beforemarking anddrilling

the holes. The two larger holesshould be located towards the top ofthe mounting

location to ensure that the ViVOpay KioskII Antennais oriented correctly with the LEDs

at the top.

1. Using the Drill Template for the antenna(630-1046-00), locate and mark the four

4.4mm (0.173 inch) mounting holes.

2. Using the Drill Template, locate and mark the two 14.0 mm (0.551 inches) across

holes (used for connectingthe antennapower and the LED power and datacable to

the ViVOpay Kiosk II).

3. Drill the four 4.4 mm (0.173) mounting holes using a number 17 drill bit.

4. Drill the two 14.0 mm (0.551 inch) holesusing a 35/64 drill bit.

5. Remove thenuts from thefour mountingscrews.

6. Route the end of the cable(220-2457-00) with the RJ45 connectorthrough the left

14.0 mm (0.551 inch) hole in to the kiosk. Make sure that the front of the antenna will

be properly oriented(not upside down)on the kiosk before inserting the fourscrews

into the mounting holes.