User's Manual

9.2.4 READER#2 MODE
READER#2 MODE setting is the same as 9.2.3 READER#1 MODE setting.
.2.5 READER#1 PIN INPUT
9.2.6 READER#2 PIN INPUT
READER#2 PIN INPUT setting is the same as 9.2.5 READER#1 PIN INPUT setting.
9.2.7 COMMUNICATION ADDRESS SETTING
9
. ☞ The default Communication Address is “000” and set a different COMM Address for each unit in the loop.
☞. This function is for USE/UNUSE the keypad inputs for the Reader#1. The default setting is UNUSE the
keypad inputs. If you want to access the door by entering the user ID by keypad, set this mode USE. Yo
u
have to set this mode USE when the unit is operating with Password.
Note: READER#2 is an external Exit reader of the unit.
ID(PIN) ONLY: The door is accessible by just presenting the proximity card(or Press the ID Number).
ID+ P/W: The door is accessible by presenting a card and Password.
35