User's Manual

Table Of Contents

7. MA: MA is the Reader#1 (Built-in Reader) Operating Mode for the cardholder. If you put ‘1’ for MA,

Reader#1 is always operating on RF Only Mode.

‘0’ – System Operating Mode [F2 SETUP MENU] [READER#1 MODE]

‘1’ – ID Only Mode

‘2’ – ID + Finger Mode

‘3’ – ID + Password + Finger Mode

8. MB: MB is the Reader#2 (Exit Reader) Operating Mode for the cardholder. If you put ‘1’ for MB,

Reader#2 is always operating on RF Only Mode.

‘0’ – System Operating Mode [F2 SETUP MENU] [READER#2 MODE]

‘1’ – ID Only Mode

‘2’ – ID + Password Mode

operating time can be set for each user.

o setup Output operating time for each level, refer to the Output Setting on the [F7 SETUP MENU].

‘2’ – Level #2

9.4.2 ID DELETION

9. LV: LV is the Output Operating Level for the cardholder. Output

‘0’ or ‘1’ – Level #1

‘3’ – Level #3

‘4’ – Level #4

10. FP: FP is the Fingerprint Usage Flag (1 digit). You can assign the user who uses fingerprint or not.

‘0’ – User without Fingerprint

‘1’ – User with Fingerprint

. ☞ Registered ID will be deleted in the controller by presenting the card or input the ID number from the keypad.

Present the card to be deleted. The ID number will appear on the LCD. If you don’t have the card, input 8digi

DELETED”

number and <ENT> key from the keypad. If the ID number is found, the ID will be deleted and display “ID

. If the ID number is not found, the display will show “ UNREGISTERED ID”. You may repeat ID

ELETION many times.