User's Manual

☞ No problem with accessing by card, but cannot access with the PIN input.
Cause An error in Setup or possible component defect.
Solution 1. Check whether a beep sound is generated when you press a key.
When a beep sound is generated, the problem may be an error in setup. Proceed like followings:
000” default) to enter the Setup mode.
- [LANGUAGE] will appear on the LCD, then use the key <6> to choose [RD1_PIN_INPUT] and
SE’ as wanted.
2. When th sound or already enabled Key-in functions, contact a designated service center.
- Enter the Master ID (“00000
- Press <F2> key.
select ‘U
ere is no beep
ime out erro
up mode, it is programmed to do so when there is no key-in or reading card within 60
☞ The Setup mode suddenly goes back to the Normal operating mode.
Cause T r
Solution In the Set seconds.
☞ Keeps making buzzer sound: “beep~ beep ~ beep” or “beeeeeeeep~~~~”.
olution 1. Check the door status. It occurs in case that the door is o
open time.
Check the door contact sensor type: it should be NO type.
Check in [7. OUTPUT T/S] of F6, the ten Ti
schedule code is set between 01 up to 10 and if the p
If it is set to unintended value, change it to “00” ( Programmab
4. Check in Tamper switch of GE314.
Cause Error in Installation, Door status or Internal circuits.
S pened over 3sec(Default) after the proper door
2.
3. me schedule code (01~10) value of output T/S. If the time
resent time is included in the schedule.
le via PC software)
5. If the trouble remains after checking the above, contact a designated service center.
64