User's Manual

17
7.4 COMMUNICATION ID SETTING
LX006 can upload/ download user’s information by application software and adjust setting values.
Communication ID is the unique communication address to recognize each LX006 in the software so
each communication ID on the same communication loop must not be duplicated.
There is 8-bit DIP switch on the back of LX006 for communication ID setting and each channel of
DIP switch has assigned address values. The communication ID is calculated by the sum value of
each bit set to “ON” position. Communication ID can be set from ‘0’ to ‘255’. Refer to examples below
to set communication ID.
Each communication ID in the same communication loop must not be duplicated. If the same
communication IDs are on the loop, it may cause communication error.
Example 1
Example 2
Example 3
1+2 = 3
(Communication ID = 3)
4+32 = 36
(Communication ID = 36)
128= 128
(Communication ID = 128)
(Figure: Communication ID Setting Example)
Cautions