User's Manual

12.3.2 Voice Volume

12.3.3 Arm/Disarm

12.3.4 Two Men Mode

The LX505 tells you its status out loud. You can adjust the volume of the voice from 0 (mute)

to 4 (maximum). New voices can be downloaded through communications with the host PC.

This setting allows you to set the Arm Code and the Disarm Code. After setting the Arm

Code or Disarm Code, you can set the LX505 to the ARM mode by entering the ARM code

and presenting an ARM/DISARM card (i.e. a card that was registered with Code 3). In this

mode, the LX505 can generate outputs so that it can operate with other security systems.

Once this mode is set, all readers stop reading cards. To DISARM the LX505, enter the

Disarm Code and present an ARM/DISARM card.

CAUTION

The ARM Code, DISARM Code, and Duress Code must all differ.

To apply this feature, cards designated for guides should be registered into the Admin

Group(C:1) as ID(1) and visitor cards into the Visitor Group(C:2) as ID(2). If configured in the

two-man mode, the LX505 won't grant access until one ID(1) guide card and one ID(2)

visitor card are presented in a series within a certain time length.