User's Manual

12.5.12 Cut Off Check Setting

12.5.13 Input Type Setting

You can assign a Time Schedule Code to each Input. The default Time Schedule Code for

every input is “00”, which means no Time Schedule is applied to them. Changing these

settings can be very useful when you want to activate PIR sensor input during a certain

period of time.

Press <ENT> key to enter this setting mode, then enter a 2-digit Time Schedule Code for

each input.

EX: EXIT Button Input T/S Code

DC: Door Contact Sensor Input T/S Code

I1: Aux Input#1 T/S Code

I2: Aux Input#2 T/S Code

TP: Tamper Switch Input T/S Code

You can choose whether or not to check the connection cutoff of each input port. ‘00’

means not using this feature and ‘01’ means using it.

CAUTION: Before setting this setting to USE, a 2.2K resistor should be connected

between the input wire and the GND.

You can program each input for either NO(Normally Open) or NC(Normally Close) operation.

‘00’ means NO while ‘01’ means NC. The default setting is 00(NO).