User's Manual

7. C – stands for the ID code. Code ‘0’ is default and code ‘1’ or ‘2’ is a code used for the

TWO MEN MODE. Code ‘3’ is used for the ARM/DISARM function and code ‘4’ is assigned

for lost cards.

8. MA – refers to the Operating Mode of the Reader#1 (i.e. the built-in reader) for the

cardholder. If you enter ‘1’ for MA, for example, Reader#1 will be operating always on RF

Only Mode.

• ‘0’ – System Operating Mode (Path: [F1 SETUP MENU] > [READER#1 MODE])

• ‘1’ – ID Only Mode

• ‘2’ – ID + Password Mode

9. MB – refers to the Operating Mode of the Reader#2 (Exit Reader) for the cardholder. If you

enter ‘1’ for MB, for example, Reader#2 will be operating always on RF Only Mode.

• ‘0’ – System Operating Mode (Path: [F1 SETUP MENU] > [READER#1 MODE])

• ‘1’ – ID Only Mode

• ‘2’ – ID + Password Mode

10. LV – refers to the Output Operating Level for the cardholder. Output operating time can be

set for each user. To configure an Output operating time for each level, refer to the

instructions on Output Setting in the [F6 SETUP MENU].

• ‘0’ or ‘1’ – Level #1

• ‘2’ – Level #2

• ‘3’ – Level #3

• ‘4’ – Level #4

•

12.7.2 ID Deletion

Registered IDs can be deleted from the LX505 by presenting the card or entering the ID

number. After entering the ID DELETION mode, present the card you want to delete.

Alternatively, you may enter an 8 digit ID number and press <ENT> key from the keypad.

The ID number will appear on the LCD and that ID will be removed from the device and the

“ID DELETED” message will be shown on the LCD. If the ID number is not found, the

“UNREGISTERED ID” message will appear. You can delete multiple IDs by repeating this

rocess.