User Manual

- 6 -
7. Operation
7.1 INITIAL SETTINGS:
STAR100R HAS COMPLETELY BLANK WHEN IT IS DELIVERED TO
CUSTOMER. THE UNIT AUTOMATICALLY ENTERS TO INITIAL SETTING
MODE WHEN IT IS POWERED ON. (YOU MAY ALSO ERASE ALL MEMORY
BY CLOSING A JUMPER ON "JP3" OF MAIN P.C.BOARD)
PROGRAMMING SEQUENCE IS AS FOLLOWS;
- Connect 12V DC Power supply to RED(+) and BLACK(-) cable.
- Power switch on. (RED LED will lit and YELLOW LED is blinking every seconds).
- Press the keypads as follow.
“01”+(ENT) RF only mode
Present Master RFID on the cabinet Register Master RFID
Present User RFID Register User RFID
... “
... “
... “
… “
Present Master RFID on the cabinet Finish RFID registration
“xxxx”+(ENT) Register 4 digits PASSWORD
Note: Master RFID can be used for setting changes and add/delete User RFID so you must keep
Master RFID to SECURE LOCATION.
THE UNIT NOW ENTERS TO NORMAL OPERATING MODE.
WITH ABOVE SEQUENCE YOU ALREADY REGISTERED "MASTER RFID" AND "USER
RFIDs" AND THE OTHER DEFAULT SETTINGS ARE AUTOMATICALLY SET AND STORED
INTO FLASH MEMORY.