Owner's Manual

ADS-RR(SR)-GMS05-DS maestro.idatalink.com
gmc Yukon xl with nav 2012-2014
Automotive Data Solutions Inc. © 2018
4
INSTALLATION INSTRUCTIONS
STEP 1
• Unbox the aftermarket radio and locate its main harness.
• Connect the wires shown on the next page from
aftermarket radio main harness to the GM2 T-harness and
match the wire functions.
• Remove the factory radio.
STEP 2
• Connect the GREEN male 2 pin connector of the backup
camera cable to the GREEN female connector of the
backup camera adapter. Connect GRAY connector of
adapter to the vehicle backup camera harness.
STEP 3
• Connect the factory harness to the GM2 T-harness. Ensure
that the RED 2 pin plugs are connected.
STEP 4
• Plug the OBDII connector into the OBDII of the vehicle,
under driver dash.
STEP 5
• Plug the aftermarket radio harnesses into the aftermarket
radio.
• Connect the backup camera RCA cable into the
aftermarket radio.
• Plug the Data cable to the data port of the aftermarket
radio.
• Insert the Audio cable into the iDatalink 3.5 mm audio jack
of the aftermarket radio.
STEP 6
• Connect all the harnesses to the Maestro RR module then
test your installation.
TROUBLESHOOTING TIPS:
• To reset the module back its factory settings, turn the key
to the OFF position then disconnect all connectors from
the module. Press and hold the module’s programming
button and connect all the connectors back to the module.
Wait, the module’s LED will fl ash RED rapidly (this may
take up to 10 seconds). Release the programming button.
Wait, the LED will turn solid GREEN for 2 seconds.
• For technical assistance call 1-866-427-2999 or e-mail
“[e-mail]”. Visit us at “maestro.
idatalink.com/support” and “www.12voltdata.com/forum/”
2