Installation Instructions

12
Fig. 10-S
End Stile
Track
Engaging
Slot
Fig. 9-S
Fig. 8-S
End Stile
Top of Section Top of Section
(3) #14 x
5
/8"
Sheet Metal
Screws
Roller
(4) #14 x
5
/8"
Sheet Metal
Screws
Roller
4"
4"
Lock Installation
Step 4: The following locking systems are available
for commercial steel doors:
•Side Lock (FIG. 8-S)
•Inside Slide Bolt (FIG. 9-S)
1. Attach the side lock assembly to the second
section. Unless otherwise specified, this stile will
be located 18" in from the right hand side of the
door (inside facing out). Secure the lock cylinder
#2 with the two long machine screws as illustrated.
Attach the handle (1) and inside lock mechanism
(7), using the fasteners provided.
NOTE: 1
3
/4" thick doors should use the 1
3
/4" pan
head machine screw (9) provided in the lock bag
to mount the outside handle. 1
3
/8" thick doors
should use the 1
1
/2" pan head machine screw
provided.
2. Finally, attach the lock bar (11) using
1
/4" x 20 x 1"
hex head screw and nut (10 & 12), and lock bar
guide (14) using #14 x
5
/8" sheet metal screw.
When track is permanently in place, adjust the
lock bar guide so lock bar rests against the top of
one of the engaging slots in the track. Details are
shown in Figure 8-S.
3. The inside slide bolt is installed on the end stile of
the second section so the slide bolt rests against
the top of one of the rectangular engaging slots in
the vertical track. Details are shown in Figure 9-S.
Step 5: #3 Section (and up to, but not including, top
section). Attach bottom half of center hinges to top of
section using #14 x
5
/8" hex head sheet metal screw.
Attach end hinges. (See Figure 2-S, page 8, for
sequence.) After section is stacked, rollers in the
track will hold section in place. (If struts are supplied
see Figure 3-S, page 9, for placement.)
Step 6: Continue to stack and install remaining
sections in the same manner as described in Step 5
until all but the top section are properly in place.
Step 7: Top Section. Place top brackets over pre-
punched holes so they are flush with edge of sec-
tion. Center of roller carrier will be about 4" down
from top of section. Using four #14 x
5
/8" hex head
sheet metal screws per top bracket, attach top
brackets to section. (FIG. 10-S) (Low headroom
doors
3
/4" refer to Figure 7-T, page 23.)
If struts are supplied see Figure 3-S, page 9, for
placement.
Stack top section after all tracks are installed, but
before springs are wound.
Track
18" To
End Of
Panel