Installation Instructions

16
Step 1: Vertical Track. Center bottom section in
opening on inside of garage. Level section by
blocking up low side. (FIG. 2-T) Leave block until
door is completed. Install the vertical track on
opposite side of where block was placed, over the
two rollers of the bottom section with a twisting
motion as in Figure 3-T. Raise track
1
/2" off the
floor, Figure 2-T, and screw
5
/16" x 1
5
/8" lags
(wood jambs), or self-drilling screws (steel jambs)
through bottom mounting bracket. (FIG. 4-T)
Adjust track sideways to allow
1
/8" end play in
roller—about
1
/4" from edge of track to edge of
door. (FIG. 2-T) Plum vertical track and put
at least two lags or sheet metal screws in the
mounting brackets at the top of the door. Final
adjustment will be made after door is stacked.
Measure from the top of the vertical track to the
top of the bottom section and set the opposite
track at exact same height repeating above
procedure. (FIG. 2-T) Since the bottom section
is level, then the vertical tracks must be level.
Make sure bottom rollers do not come out
of the bottom of the track.
Step 2: Stacking. Stack #2 section on top of
bottom section and attach end hinges with rollers
in track to hold section in place. Stack the rest of
the sections except the top (the top section must
be installed after all the tracks are up).
Swing up top half of hinges and use #14 x
5
/8" hex
head sheet metal screws to fasten door.
Step 3: Finishing Vertical Track. Set the top of
the vertical tracks so that there is
1
/4" end play in
the rollers, about
1
/2" from edge of track to edge of
door. (FIG. 2-T) Finish attaching vertical track to
the wall. If you are mounting on steel jambs, you
will have to wait until you can raise the door to
finish attaching vertical tracks.
NOTE: To complete the rest of the track installa-
tion, refer to the page explaining your specific lift
option:
Standard Radius................................ Page 17
Roof Pitch .......................................... Page 23
Low Headroom Rear Mount .............. Page 24
Low Headroom Front Mount .............. Page 26
Vertical Lift ......................................... Page 27
High Lift ............................................. Page 28
Fig. 4-T
Fig. 2-T
Fig. 3-T
Allow
1
/2"
Between Track
And Door
Allow
1
/4"
Between Door
And Track
ASSEMBLY MAY BE ADJUSTED ALONG JAMB
5
/16" x 1
5
/8" Lag Screw
(7) Shown
Note: Track Can Be
Adjusted By Shifting
The Track Brackets In
The Slots Where The
5
/16" x 1
5
/8" Lag
Screws Are Installed.
End Stile
Track
Rotate Into Place
Door
Jamb
Roller
Hinge
Block To
Level
Floor
Line
Jamb
Vertical Track
This
Measurement
Must Be Equal
On Both Sides
Hold Track
1
/2"Off Floor
Commercial
Vertical Bracket