Installation Instructions

4
SAFETY INFORMATION
I M P O R T A N T !
To Protect Yourself From Injury
Carefully Read The Following Safety
Information And Warnings Before You Install
Or Attempt To Repair Your New Garage Door
•Track installations must use sway braces on the rear track hangers to prevent sideways movement. If the
tracks are not firmly stabilized they might spread, allowing the door to fall and cause severe injury and
damage.
•The center torsion spring assembly uses a wooden pad (2" x 6" x 12" minimum) or steel plates (
1
4" thick
x 10" x 12" minimum) that must be of good quality and firmly attached to the wall. Four
3
8" x 3" lag
screws should be used to attach wood structure. The wood needs to be made of a Grade 2 or better
Southern Yellow Pine (also known as Southern Pine or Yellow Pine.) DO NOT use wood labeled as
Spruce-Pine-Fir (or SPF). Four
3
8" masonry anchors can be used on concrete or block walls. If the wood
splits once the torsion spring is in place, it should be replaced by a professional installer. Do not try to
remove or repair a torsion spring assembly or any red-colored fasteners once it is wound.
Springs, cables, and bottom fixtures are under strong spring tension. Do not attempt to loosen any
fasteners on these components. You could suddenly release spring forces and risk severe injury.
If the garage door and/or any of the supporting track are damaged, operating the door could be hazard-
ous. Call an authorized representative of the manufacturer or professional door repair service promptly.
Do not permit children to play beneath or with any garage door or electric operating controls.
If repairs are ever required to your door, safety and trouble-free operation can be best assured by using
original replacement parts.
Once you have completed the installation of your new garage door, please be sure that your garage
complies with all applicable ventilation requirements before you enclose any vehicles in the garage.
Good ventilation avoids fire and health hazards caused by fumes accumulating within a well-sealed
garage.
•Clopay Building Products Company disclaims all liability for any installation which is not in compliance
with applicable state, county, or local building codes.
Doors equipped with automatic door operators can cause serious injury or death if not properly adjusted
and operated. To insure safe operation of these doors:
a) test the sensitivity of the operator’s safety reverse mechanism monthly;
b) remove the pull rope;
c) make sure the door remains unlocked;
d) do not allow children to play with the controls.