User manual

Page 19 Page 20
Identifyingdownstreamloadsfromabreaker.
1) Removethepanelcoverandclamparoundthehotwireoftheenergized(closed)circuit.
 • Tomaximizethesignal,closethefarendofthecircuitbyplugginginandturning
   onaworklightorotherloadintothefurthestoutlet;hence,makingacomplete
   loop.
2) Hangthebatterypackontothepanelwiththemagneticstrap.
3) Plugtheclampintothebatterypack.
4) Setthereceivertothehighestsensitivitymode()andtracethecircuittothefurthest
outletwhileidentifyingalloutletsandloadsconnectedtothecircuit.IftheReceiveris
 saturated,reducethesensitivityrange.
TracingConduit.
1) Clamparoundthemetallicconduittobetraced.Ifpossible,groundthefarendofthe
conduittoclosetheloop.Thiscanbecreatedusingthe25’leadandalligatorclipstoclip
ontotheendoftheconduitorelectricalboxwithoneclipandaremoteneutralorwater
pipewiththeotheralligatorclip.
2) Hangthebatterypackontothepanelorconduitwiththemagneticstrap.
3) Plugtheclampintothebatterypack.
4) Setthereceivertothehighestsensitivity()modeandtracetheconduit.Ifthe
Receiverissaturated,reducethesensitivityrange.
Tracingindustrialcontrolcircuits.
1) Ensurethatthecircuitisenergized(closedatthepanel)ataminimum.Tomaximizethe
signal,closetheotherendofthecircuitbyturningonaload,suchasamotororpump.
2) Clamparoundthehotwireofthisenergized(closed)circuit.
3) Usethemagneticstraptohangthebatterypackontothepanelorthemotorcontrol
cabinet.
4) Plugtheclampintothebatterypack.
5) Setthereceivertothehighestsensitivity()modeandtracethecircuittotheother
end.Ifthereceiverissaturated,reducethesensitivitymode.
Battery Replacement
Transmitter:
Ensurethatthetestleadsareremovedfromtheinput
jacksandthecircuitundertest.
1) Removethebatterycapbylooseningthescrew.
2) Replacebatterieswith(4)newAAbatteries.
3) Assemblecapandre-tightenthescrew.
WeakerSignal-Open
StrongerSignal-Closed
LightOn
(Load)
Breaker
Energized
Breaker
Energized