Installation Instructions

VDV MultiMedia Cable Tester has the ability to turn off the split pair error testing. Pressing

the button for the current cable test mode for more than 2 seconds turns off the split pair

testing. The “Split” icon and the word “OFF” appears on the screen momentarily to indicate

this. The split pair testing will resume the next time the tester is turned on, or may be toggled

back on by another 2 second press of the current test mode button.

BATTERY REPLACEMENT

When the battery low icon is on, the battery should be replaced as soon as practical.

The cable testing results will become unreliable when the battery reaches about 4.5 volts.

To replace battery:

1. Remove the screw from the battery door on the back of the unit with a

#1 Phillips-head screwdriver.

2. Pull battery out of cavity and remove battery snap.

3. Connect a new Alkaline 9 volt battery to battery snaps. Place battery back into body

with battery snaps placed toward front end of compartment.

4. Replace battery door and screw being careful to not over tighten the screw.

SPECIFICATIONS

Physical Dimensions

Size: 13.2 × 7.3 × 4.1 cm (5.2 × 2.9 × 1.6 inches)

Weight: 242 grams (8.5 oz.) with battery and remote

Environmental

Operating temperature: 0 to 50 °C (32 to 122 °F)

Storage temperature: -10 to 60 °C (14 to 140 °F)

Humidity: 10% to 90%, non-condensing