Boiler User Manual

ManualsBrandsIDEAL INDUSTRIES ManualsBoilerMINI HE C24

mini HE

When replacing any part of this appli ance, use only spare parts that you can be

assured conform to safety and performance specification that we require. Do not use

reconditioned or copy parts that have not been clearly authorised by Ideal Boilers

Your Ideal us ers guide

For installation and servicing guide see

reverse of book

users guide

C24,C28

Summary of content (4 pages)

PAGE 1
users guide mini HE Your Ideal users guide C24,C28 For installation and servicing guide see reverse of book When replacing any part of this appliance, use only spare parts that you can be assured conform to safety and performance specification that we require.
PAGE 2
mini HE mini HE C24 mini HE C28 G.C. appliance No. 47 ---348 ---38 G.C. appliance No. 47 ---348 ---39 Destination countries: GB, IE INTRODUCTION the boiler case must be allowed for servicing. After installation the following clearances are allowable during use, providing the encasing parts are removeable for servicing: The bottom clearance can be reduced to 20mm (3/4”). The front clearance can be reduced to 50mm (2”).
PAGE 3
Normally operating boiler B CH operation DHW operation In these cases, however, it is advisable to install a small water treatment device. With such a device you should avoid periodic descaling. Frost protect operation Lamp OFF Flashing lamp, alone or simultaneously with an other lamp. Flashing lamp, alternate with another lamp. If the lights sequence observed on the boiler is not included above then a fault is indicated.
PAGE 4
Points for Boiler User Note. In line with our current warranty policy we would ask that you check through the following guide to identify any problems external to the boiler prior to requesting a service engineers visit. Should the problem be found to be other than with the appliance we reserve the right to levy a charge for the visit, or for any pre ---arranged visit where access is not gained by the engineer.