Installation Guide

ManualsBrandsIDEAL Security ManualsTools & HardwareAntique Brass Coated Zinc Storm and Screen Door Lever Handle Set with Deadbolt

1.323

.875

1.750

.312

1.943 1.451

.910

.854

.061

.345

.875

.750

cutting line

2.125"

Fig 2

2.5"

Fig 1

HK357DB05

Template and installation instructions

Warning:

Check door profile prior to installation

You will require a profile wide enough for proper installation.

With the door closed, the minimum outside door profile width is 2.5” from the edge of the door frame (glass side) to the edge of the door jamb

or metal door frame (z-bar), which ever is narrower. (Fig 1)

The minimum inside door profile width is 2.125” from the edge of the door frame (glass side) to the edge of the door jamb or metal door frame (Z-bar),

which ever is narrower. (Fig 2)

Determine if your storm door is hinged right or hinge left for proper use of drilling template

From outside of door, looking in, if the hinges are on your left, your door is left handed. If the hinges are on the right, it is a right handed door.

Ensure that the inside paddle does not interfere with the prime door lock.

PAGE 1 OF 5

RFQHK357DB05

Summary of content (5 pages)

PAGE 1
HK357DB05 Template and installation instructions Warning: Check door profile prior to installation You will require a profile wide enough for proper installation. With the door closed, the minimum outside door profile width is 2.5” from the edge of the door frame (glass side) to the edge of the door jamb or metal door frame (z-bar), which ever is narrower. (Fig 1) The minimum inside door profile width is 2.
PAGE 2
Template Placement and Drilling Instructions 1. Fold the template on the dotted line to 90 according to the handedness (left or right). DOOR OUTSIDE JAMB DOOR GLASS 2. With the door in closed position, place folded template on inside of door so that the SIDE A is against the jamb or metal z-bar, which ever projects out farther; and SIDE B is on the inside surface of door. 3. Use a center punch to mark the position of 3 holes on the inside surface of door on SIDE B.
PAGE 3
SPINDLES AND SCREWS SELECTION CHART HANDLE SPINDLE SELECTION LATCH SCREW SELECTION DOOR THICKNESS DOOR THICKNESS 1" 1 1/4" 1" 1 1/4" 1 1/2" & 1 3/4" 1 1/2" 2" & 2 1/4" 1 3/4" 2" 2 1/4" 1. Print out this sheet using 1:1 scale. Verify scale using a ruler. 2. Over lay screws on top of the image. 3. Select the screws that matche your door thickness. Now the latch screws are selected and ready for installation. 1. Print out this sheet using 1:1 scale. Verify scale using a ruler. 2.
PAGE 4
Handle, Deadbolt, & Latch Installation 1. Rotate the outside handle to the left or right according to your door handedness. 2. Insert a handle spindle completely into the center hole of the outside handle from the back side. The spindle locks the handle in place. 3. Place the outside handle assembly on door. (If your door thickness is not standard then: The spindle should project through inside of door a max of 1/2" and min of 1/4". You may have to cut off spindle.) 4.
PAGE 5
DIMENSIONS 1.654 2.431 2.078 1.008 1.319 4.449 4.567 2.406 .674 .444 .500 1.091 1.5 1.465 .696 2.149 3.