Specification

g. Press PROG button eight (8) times to exit set-up mode.
6. TO PROGRAM SIREN ON/OFF
The auto-dialer has been factory pre-set with the siren ON. To turn the siren OFF:
a. Enter password followed by PROG
button four (4) times.
b. The "
" icon will flash on the auto-dialer screen. (Fig.7)
c. Press ARM/DISARM to confirm.
d. Using */UP or #/DOWN buttons to select SOUND OFF. Followed by
ARM/DISARM button to confirm.
e. Press PROG button six (6) times to exit the set-up mode.
7. TO PROGRAM AUTO CALL FUNCTION ON/OFF
The auto-dialer has been factory pre-set with the call option ON. If you do not want the
auto dialer to call out change this to OFF:
a. Enter password followed by PROG button five (5) times.
b. The " " icon will flash on the auto-dialer screen. (Fig.8)
c. Press ARM/DISARM button to confirm.
d. Using */UP or #/DOWN buttons to select call OFF followed by the
ARM/DISARM button to confirm.
e. Press PROG
button five (5) times to exit the set-up mode.
8. TO PROGRAM AUTO DIALLING CYCLE
The auto-dialer has been factory pre-set for auto dialing for 3 cycles (When water is
detected the auto dialer will call ALL stored numbers 3 times). You can change this cycle
from 1 to 5 dialing cycles.
a. Enter password followed by PROG button six (6) times.