Datasheet

www.ideal-tek.com
swiss made
This document contains information based on average values as obtained from the results of laboratory tests and observations made on the material.
Ideal-Tek SA declines all responsibility from an improper use of the product described in this document.
Engineering plastic type DG/DL
TECHNICAL DATA SHEET
General notes:
» POM/GF30 acetal resin reinforced with 30 wt% glass bre
» good tensile and exural strength, fatigue and creep resistance
» low friction, good wear and abrasion resistance
» low moisture absorption
» good chemical resistance (oils, grease, fuels, organic solvents); not resistant to strong acids, alkalis and oxidizing
agents; good hydrolytic resistance (hot water)
» insulating
» typical applications include handling of very scratch sensitive components (ceramic and glass devices, wafers, capillary)
Temp. of de. under load (1.80 MPa)
162 °C
ASTM D648
Temp. of de. under load (0.45 MPa)
165 °C
ASTM D648
Vicat softening temperature (50°C/h 50N)
156 °C
ISO 306
Coef. of lin. therm expansion, normal
4.50 E-5/°C
ASTM D 696
Continuous Use Temperature
85°C
20’000 h
Short Time Temperature
120°C
Flexural modulus +23°C
8000 MPa
ASTM D 790
Flexural modulus +60°C
5700 MPa
ASTM D 790
Flexural modulus +90°C
4500 MPa
ASTM D 790
Flexural modulus +120°C
3800 MPa
ASTM D 790
Tensile strength +23°C
83 MPa
ISO 527
Tensile strength +60°C
60 MPa
ISO 527
Tensile strength +90°C
53 MPa
ISO 527
Tensile strength +120°C
45MPa
ISO 527
Rockwell hardness M
85
ASTM D 785
Izod-Impact strength (notched) +23°C
55 J/m
ASTM D 256
Charpy-Impact strength (unnotched) +23°C
20 kJ/m
2
DIN 53453
Mechanical properties
Thermal properties
Comparative tracking index
>600 Volts
IEC 112
Electric strength (2mm)
23.0 kV/mm
IEC 243-1
Electrical properties