Datasheet

www.ideal-tek.com
swiss made
This document contains information based on average values as obtained from the results of laboratory tests and observations made on the material.
Ideal-Tek SA declines all responsibility from an improper use of the product described in this document.
High-performance plastic type CP
TECHNICAL DATA SHEET
General notes:
» PEEK polyetheretherketone reinforced with carbon nano
» very hard, rigid, high tensile and exural strength, very high wear resistance
» high heat capability (260-300°C), good dimension stability, low thermal linear expansion coecient
» excellent resistance to chemicals and aggressive agents, excellent resistance to thermal ageing
» ESD-safe material 10E
6
» typical applications include handling of components in cleaning/chemical/assembly processes also at high
temperature (soldering).
Flexural modulus +23°C
21400 MPa
ISO 178 ASTM D 790
Flexural strength +23°C
350 MPa
ISO 178 ASTM D 790
Tensile modulus +23°C
24000 MPa
ISO 527 ASTM D 638
Tensile strength +23°C
190 MPa
ISO 527 ASTM D 638
Izod - Impact strength (notched) +23°C
65 J/m
ISO 180/4A ASTM D 256
Mechanical properties
Temp. of de. under load (1.80 MPa)
300 °C
ISO 75 ASTM D648
Continuous Use Temperature
260°C
20’000 h
Short Time Temperature
300°C
Thermal properties
Surface resistivity
10
6
Ohm
Decay time
< 0.2 sec
1000-10 V
Electrical properties
Density
1.28 g/ccm
ISO 1183
Water absorption in water 23°C (24h)
0.60%
ISO 62
Other properties