Datasheet

www.ideal-tek.com
swiss made
This document contains information based on average values as obtained from the results of laboratory tests and observations made on the material.
Ideal-Tek SA declines all responsibility from an improper use of the product described in this document.
Stainless steel type SA
TECHNICAL DATA SHEET
General notes:
» Low carbon austenitic steel (Material number 1.4435, DIN X2CrNiMo18-14-3, AISI number 316L)
» contains from 16.5 to 18.5 wt% chromium and has important quantities of nickel and molybdenum as additional
alloying elements
» non-magnetizable (80%)
» good corrosion resistance to most chemicals, salts and acids
» generally used where corrosion resistance and toughness are primary requirements
» typical applications include tweezers for the electronic industry, watch-makers, jewelers and laboratory and
medical applications in moderately aggressive chemical environments
Coef. of lin. therm expansion
16.0 E-6/°C
20°C-100°C
Coef. of lin. therm expansion
17.0 E-6/°C
20°C-300°C
Specic heat capacity
0.50 J/(g
.
K)
Thermal conductivity
15 W/(m
.
K)
Continuos use temperature
350°C
Max service temperature, air
925°C
State
annealed
Density
8.0 g/cm
3
Hardness HB30
≤ 215
Hardness Rockwell B
79
Tensile strength, ultimate
500-700 MPa
Tensile strength, yield
290
0.2% Yield stress
≥ 200 MPa
Elongation, break
40%
Modulus of elasticity
200 GPa
Mechanical properties
Resistivity
0.75 E-4 Ohm.cm
Electrical properties
Thermal properties
Component Wt.% Component Wt.% Component Wt.%
C
≤0.03
Si
≤1.0
Mn
≤2.0
P
≤0.045
S
≤0.03
Cr
17.0-19.0
Mo
2.5-3.0
Ni
12.5-15.0
Composition