Hob IZGS980 EG
CONTENTS Safety information Safety instructions Product description Daily use Helpful hints and tips 2 3 4 5 5 Care and cleaning Troubleshooting Installation Technical information Environment concerns 6 7 8 10 11 Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
• Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. SAFETY INSTRUCTIONS Installation Warning! Only a qualified person must install this appliance. • Remove all the packaging. • Do not install or use a damaged appliance. • Obey the installation instruction supplied with the appliance. • Keep the minimum distance from the other appliances and units. • Always be careful when you move the appliance because it is heavy.
• Used oil, that can contain food remnants, can cause fire at a lower temperature than oil used for the first time. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. • Do not try to extinguish a fire with water. Disconnect the appliance and cover the flame with a lid or a fire blanket. Warning! Risk of damage to the appliance. • • • • • • • • • • Do not keep hot cookware on the control panel. Do not let cookware to boil dry.
DAILY USE Warning! Refer to the Safety chapters. Ignition of the burner Warning! Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame A Always light the burner before you put cookware. B To light the burner: 1. Turn the control knob counterclockwise to the ) and push it down. maximum position ( 2. Keep the control knob pushed for approximately 5 seconds; this will let thermocouple to warm up.
• When the liquid starts to boil, turn down the flame to barely simmer the liquid. Use cookware with diameters applicable to the size of burners. Burner Diameters of cookware Triple Crown 180 - 260 mm Rapid 180 - 260 mm Semi-rapid 120 - 220 mm Auxiliary 80 - 180 mm Warning! Make sure that the bottoms of pots do not stand above the control knobs. If the control knobs are under the bottoms of pots, the flame heats them up. Do not put the same pan on two burners.
Cleaning of the spark plug Periodic maintenance This feature is obtained through a ceramic ignition candle with a metal electrode. Keep these components well clean to prevent difficult lighting and check that the burner crown holes are not obstructed. Periodically speak your local Service Force Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted.
If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, speak your dealer or the local Service Force Centre. • Product number (PNC) ................. • Serial Number (S.N.) ................. Use the original spare parts only. They are available at Service Force Centre and approved spare parts shops.
Liquid gas Use the rubber pipe holder for liquid gas. Always engage the gasket. Then continue with the gas connection. The flexible pipe is prepared for apply when: – it can not get hot more than room temperature, higher than 30°C; – it is no longer than 1500 mm; – it shows no throttles; – it is not subject to traction or torsion; – it does not get in touch with cutting edges or corners; – it can be easily examined in order to make sure its condition.
Building In 30 mm min. 150 mm a 60 mm min. 650 mm min 20 mm (max 150 mm) b min. 55 mm 480 mm 30 mm 830 mm A) Removable panel B) Space for connections Kitchen unit with oven A 10 mm 3 mm 27 mm 27 mm The hob recess dimensions must obey the indication and the kitchen unit must be equipped with vents to let a continuous supply of air. The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven from the unit.
TOTAL POWER: G20 (2H) 20 mbar = 13.0 kW G30 (3+) 28-30 mbar = 931 g/h G31 (3+) 37 mbar = 914 g/h Electric supply: 230 V ~ 50 Hz Category: II2H3+ Gas connection: R 1/2" Gas supply: G20 (2H) 20 mbar Appliance class: 3 By-pass diameters Burner Ø By-pass in 1/100 mm Burner Ø By-pass in 1/100 mm Auxiliary 28 Rapid 42 Semi-rapid 32 Triple Crown 56 Gas burners NORMAL POWER NORMAL POWER REDUCED POWER kW kW inj. 1/100 mm m³/h inj. 1/100 mm 1.0 0.33 70 0.
397186501-C-292012
