User manual

15
Operating sequence
1. Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in
the drum, one item at
a time, shaking them
out as much as
possible. Close the door.
2. Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
and, if you wish to carry out a programme with
the prewash phase or the soak programme,
pour it into the compartment marked .
If required, pour fabric softener into the
compartment marked (the amount used
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
Select the required programme by means of
the programme selector dial
(1)
Turn the programme selector dial to the
required programme.
The green light of button 8 starts to flash.
It can be turned either clockwise or
anticlockwise.
On position «O» the programme is reset and
the machine is switched OFF.
At the end of the programme the selector
dial must be turned to position «O», to
switch the machine off.
ATTENTION!
If you turn the programme selector dial to ano-
ther programme when the machine is working,
tthe red pilot light of button
8 will flash 3 times
and the message Err is displayed on the dis-
play to indicate a wrong selection. The machi-
ne will not perform the new selected program-
me.
Select the spin speed, the «Night Cycle» or
«Rinse Hold» option by pressing button
2
When selecting a programme, the light
corresponding to the maximum speed allowed
for that programme will illuminate. The relevant
light will light up (refer to the chapter
«Programmes table» for the maximum allowed
by each cycle spin speed).
Select the desired option by pressing the
buttons
3
, 4, 5 and
6
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired programme
and before pressing the button 8.
For the compatibility of the options with the
washing programmes, refer to the section
«Programmes table».
Start the programme by pressing button
8
To start the selected programme, press this
button; the corresponding green pilot light
stops flashing. The pilot light 9 illuminates to
indicate that the appliance starts operating and
the door is locked.
IMPORTANT!
If an option which is not compatible with the set
wash programme is selected, the message Err
is displayed for few seconds and the red light
of this button flashes for 3 times.
132961470.qxd 24/09/2008 10.30 Pagina 15