User manual

16
Select the delayed start by pressing the
button 10
Press these buttons to select the required
delay.
The selected delay time value will appear on
the display for a few seconds, then the duration
of the programme will appear again.
You must select this option after you have set
the programme and before you press the
button
8.
You can cancel the delay time at any moment,
before you press button
8. If you have already
pressed it, and you wish to cancel the delay
time, proceed as follows:
• set the washing machine to PAUSE by
pressing button
8;
• press the button
10 once. On the display will
appear the symbol «0’».
• press button
8 again to start the programme.
IMPORTANT!
• The selected delay can be modified only after
you have turned the programme selector dial
to the «O» position and after you have
selected the programme again.
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing button
8 and wait a few minutes
until the pilot light
9 goes off before opening
the door. After you have closed the door,
press the same again.
Note!
The Delay Start cannot be selected with
«Drain» programme.
Display
The display shows the following information:
After selecting a programme the duration of
the selected programme appears on the dis-
play.
During the program-
me, the time remai-
ning is updated every
minute.
The Delayed start appears on the display for a
few seconds, then the duration of the
previously selected programme is displayed.
The delay time value
decreases by one unit
every hour and then,
when 1 hour remains,
every minute.
The incorrect option selection is indicated by
the message Err displayed for a few seconds
and by flashing of the light button
8.
In the event of operating problems, some
alarm codes can be displayed, (see paragraph
“Something not working”).
The End of programme is indicated by a
flashing zero «
0».
0
E20
2.00
132961470.qxd 24/09/2008 10.30 Pagina 16