User manual

17
Altering an option or a running programme
It is possible to change some options before
the programme carries them out.
Before you make any change, you must pause
the washing machine by pressing button
8.
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «O» and then to the new
programme position. Start the new programme
by pressing button
8 again.
The washing water in the tub will not empty
out.
Interrupting a programme
Press tbutton
8 to interrupt a programme which
is running, the corresponding light starts to
flash. Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «O» to cancel a
programme which is running. A new
programme can now be selected.
Opening the door after the programme has
started
First set the machine to pause by pressing the
button
8.
If the pilot light 9 flashes and after a few
minutes goes off, the door can be opened. If it
remains lit, this means that the machine is
already heating or that the water level is above
too high. In this cases the door cannot be
opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «O». After few
minutes the door can be opened
(Pay attention to the water level and
temperature!).
After this procedure, it will be necessary to set
the programme and the options again and then
to press button 8.
At the end of the programme
The machine stops automatically. Some
acustic signals sound and on the display will
appear a flashing «
0 ». The button 8 light and
the pilot
light
9 go off. The door can be
opened.
If at the end of a programme there is water in
the tub, to empty out the water follow the
following instructions:
1. turn the programme selector dial to «O»
2. select the DRAIN or SPIN programme
3. reduce the spin speed, if needed, by
pressing the button
2
4. press button 8
5. at the end of programme, the display shows
a flashing zero «0», the pilot
light
9 goes off
and it will be possible to open the door.
At the end of the cycle, turn the programme
selector dial to «O» to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
132961470.qxd 24/09/2008 10.30 Pagina 17