User manual

26
Water inlet
The inlet hose is screwed on the back of the
appliance
Do not use the hose from your previous
machine to connect to the water supply.
Do not place the inlet hose downwards.
Angle the hose to the left or right depending
on the position of your water tap.
Set the hose correctly
by loosening the ring
nut.
After positioning the
inlet hose, be sure to
tighten the ring nut
again to prevent leaks.
Connect the hose to a tap with a 3/4” thread.
The appliance must be connected to a cold
water supply.
The inlet hose must
not be lengthened. If it
is too short and you do
not wish to move the
tap, you will have to
purchase a new,
longer hose specially
designed for this type
of use.
Water drainage
The end of the drain hose can be positioned in
three ways:
Hooked over the
edge of a sink using
the plastic hose
guide supplied with
the machine. In this
case, make sure the
end cannot come
unhooked when the
machine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.
HEC0006
In a sink drain pipe branch. This branch
must be above the trap so that the bend is at
least 60 cm above the ground.
Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter
of the drain hose.
The drain hose must not be kinked.
Electrical connection
This machine is designed to operate on a 230
V, single-phase, 50 Hz supply.
Check that your domestic electrical installation
can take the maximum load required (2.2 kW),
also taking into account any other appliances
in use.
Attention!
Connect the machine to an earthed socket.
The manufacturer declines any responsibility
for damage or injury through failure to comply
with the above safety precaution.
Should the appliance power supply cable
need to be replaced, this should be carried out
by our Service Centre.
NOTE
Please ensure that when the appliance is
installed it is easily accessible for the engineer
in the event of a breakdown.
132961470.qxd 24/09/2008 10.30 Pagina 26