Instructions / Assembly

Sharpening an Auger Bit
Inspection
• Lead-Screw
• Straightness
• Cutting Edges
Spurs
Roll without wobble = Good
File
Top Surface
Barricade
Slanting Surface
Step
Nailbiter™ Auger Re-Sharpening
Description
Lead-screw must be straight, complete and pointed.
Threads on lead screw pull the auger through the wood, so a damaged
lead screw renders an otherwise good auger useless.
Straightness is critical for safety, efficiency and control. Roll the auger on
a flat surface to verify it is straight. Scrap warped augers.
Augers with dull edges can usually be sharpened, but damaged edges
(notches, cracks, missing spurs) cannot be saved. Scrap damaged
augers.
It is common practice in the field to re-sharpen augers between jobs. The
NailBiter™ can be easily and repeatedly re-sharpened. The time it takes to
re-sharpen a good auger equals a fraction of the cost to replace one.
NailBiters™ are full body hardened (steel is completely hardened through
the entire bit) to take numerous re-sharpenings. Competitors’ surface
hardened augers quickly lose the hardened outer steel and can’t be kept
sharp.
1. Top surface and slanting
surface create primary cutting
edge.
2. Grind the slanting surface until
cutting edge becomes smooth.
3. Step creates barricade on top
surface.
4. Remove barricade by grinding
top surface to only one
direction.
Sharpening Preparation:
• Select a small, smooth feather edged flat file. A file that is too large will
limit your range of motion and may cause accidental filing on surfaces
that should not be contacted
• Set the screw point of the auger down on a piece of wood with the
other end pointing up at approximately 45°. The wood protects the
screw point from being damaged while the bit is being sharpened.
If your auger has lead spurs, never file them on the outer surface. You’ll
reduce their cutting radius, resulting in the body of the auger forcing
its way through the smaller radius and binding in the bore. Only file the
interior surface of spur edges.
Most professional quality augers are made of high-carbon alloy steel,
hardened to Rockwell R56 or higher. That means they’ll stand up to lots of
use, but also means a file has to be much harder than the auger to be able
to dress a fresh edge on the cutters.
Description
IDEAL INDUSTRIES, INC.
Sycamore, IL 60178, U.S.A.
800-435-0705
www.idealindustries.com
IS 0002-1