Instructions / Assembly

3
#ofLumens
Area(sq.footorsq.meter)
Lumens=#feet(meters)xarea
Foot-candle/Luxconversion
1foot-candle=10.764lux
1lux=0.09290foot-candles
(sq.feetorsq.meter)
OPERATING THE METER
1. Pressthe““buttontoturnthepoweronoroff
2. Removethesensor’scapandplacethesensorintheareatobemeasured.
3. PresstheLUX/FCbuttontoselectthedesiredunitsofmeasure.FCisthe
default.
4. Readthelightlevelonthedisplay.Ifthemeterisinautorangemode,the
 readingautomaticallyappearsonthedisplay.Ifthemeterisinmanual
 rangemodeandthemeasurementisoutofrange,anOLappearsinthe
 display.PresstheMANUbuttontochangetherange.
5. TosavethecurrentvalueontheLCDpresstheDataHoldbutton.Press
 theDataHoldbuttonagaintoresumenormalmeasuring.
6. Tocapturethemaximumreadingwhiletakingmeasurements,presstheMax
 Holdbuttontocapturethemaximumvalue.PressmaxHoldbuttonagainto
resume normal measuring.
7. Iftheunitisidleforapproximately5minutes,itwillautomaticallypoweroff.
8. Aftertesting,replacethelightsensorcapandpressthepowerbuttontoturn
off the meter.
ZEROING THE METER
Turnthemeteronwiththesensorcapinplaceoverthelightsensor.Thevalue
shouldread000inanyrange.Ifthemeterdoesnotread000,pressthezero
buttontoautomaticallyzerothereading.
•