Installation Guide

5
6
Resistance (Ω)/Continuity •
)))
1. Turn on the instrument.
2. Press two times to select Ω/•
)))
.
3.Inserttestleadsintothecorrespondinginputterminals.
4.Applytestleadstode-energizedcircuitandpresstoperform
the measurement.
5.Applytestleads:
 • Theohmsvalueisdisplayed.
 • If<30Ω, continuity beeper also sounds.
Note:Pressandtoperformmeasurementsincontinuous
mode.LOCKisdisplayedandAPOisdefeated.
For higher accuracy and resolution:
•PresstoselectLoΩ(0.00-19.99Ω).
•Null(ZERO)testleadsbytouchingtestleadtipstightlytogether. 
Press >2 sec. The resistance of the leads is now subtracted from
pending measurements until is pressed again.
•Repeatsteps3-5totakeresistancemeasurements.
TEST
TEST
LOCK
61-795
Digital Insulation Tester
1000V
Test
MΩ
500V
MΩ
250V
MΩ
Red
Black
BOILER
R
E
Ω
Voltage - AC/DC
1. Press to turn on the instrument
2.ThemeterdefaultstoVAC(V).
 • ToselectVDC(V),pressonce.
3.Inserttestleadsintothecorrespondinginputterminals.
4.Connecttheleadstothecircuitundertest.Thevoltagevalueis
displayed.
~
61-795
Digital Insulation Tester
1000V
Test
MΩ
500V
MΩ
250V
MΩ
Red
Black
P
N
PE
R
E
R
T
V
ZERO
ZERO