User Guide

Form number TM61920 Rev 4 July 2008
Page 9
(5.3) Adjust the current range (cont’d.)
(d). 30.0A adjustment
Press the MEM/MODE button once.
Generation current: 30A@50Hz
Press the MEM/WRITE button after the reading becomes stable.
(saving the adjustment value)
(6) Press the POWER button to power off the unit and replace the front decal, making sure the plastic switch
extensions are in place.
(7) Disassembly
Removal of battery cover
Loosen one battery cover-fixing screw, and remove the battery cover.
(7.1) Removal of Front panel
Loosen three front panel-fixing screws.
Remove the front panel from the bottom case.
Note: Care should be taken not to lose the snap band and button spacer.
(7.2) Removal of PCB
Loosen three PCB-fixing screws.
Remove the wires for jaw and battery contact.
Remove the finished PCB from the bottom case.
(7.3) Removal of jaw
Loosen two jaw-fixing screws.
Remove the finished jaw from the bottom case.
(7.4) Component Layout (Figure 5)
Figure 5 - Component layout