Installation Guide
STEP 1: ATTACH
ALLIGATOR CLIPS
STEP 2: PLUG LEADS
INTO TRANSMITTER AND
TURN IT ON
STEP 3: TURN ON
RECEIVER AND TRACE
Using appropriate
safety methods,
attach the alligator
clips with 3 ft. leads
to the Hot and
Neutral conductors
on the supply side
of the branch
circuit.
Begin tracing the wires
buried in the ground by
following the strongest
signal, and adjusting the
sensitivity to obtain
readings in the
60’s to 80’s.
The orientation of the receiver to the wiring
affects the displayed signal strength.
Simply adjust the orientation of the
Receiver relative to the buried conductor to
maximize the displayed signal strength.
Use appropriate methods and LO/TO to
ensure the conductors are de-energized
and locked out before proceeding.
Verify that you de-energized the correct
conductors before proceeding when
possible. Re-energize after the transmitter
is attached.
Note: The strongest tracing signal will
always be accomplished by connecting
to a closed loop energized circuit with an
active load.
Note: The circuit in these pictures has been de-energized and locked out in accordance with NFPA 70E.
BURIED CONDUCTOR
FIND IT